ELTRON ECLIPSE DRIVER
This option requires basic OS understanding. The sensor Hole Position position is indicated by the green arrow at the front of the label guide that is visible with the printhead open. This document and the information contained within is copyrighted by Eltron International Incorporated and may not be duplicated in full or in part by any person without written approval from Eltron. The printer may stop a label in the middle. Refer to Appendix B for complete supplies ordering information.
|Date Added:||10 December 2011|
|File Size:||59.59 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
ELTRON LP USER MANUAL Pdf Download.
Due to manufacturing differences in label stock, the sensor may have difficulty distinguishing the difference between the labels and the liner. If they cannot help you, or at their direction, Eltron Technical Support can be reached at: Use onlyEltron approved labels and tags.
For additional information on serial cable wiring, refer to Appendix A – Trouble Shooting. If the FEED button is pressed and held, the printer will feed a single label, stop, feed a single label, stop, and so on until the FEED button is released.
Ensure that print mode program settings match the print mode. KDU or scanner 32 Rev.
Zebra/Eltron 2044/2046/Eclipse TR4085plus Resin Enhanced Wax
Page 52 Eltron International, Inc. See the EPL2 Configuration programmer’s manual for details. Create-A-Label Tools software disk with on- line documentation. After the sensor has been adjusted, the printer will enter DUMP mode and print the elltron information label.
Eltron Eclipse Driver Download Version
If the indicators fail to flash and label stock is not loaded, then refer to Appendix A – Trouble Shooting. Label Variations and the Label Sensor. This document and the information contained within is copyrighted by Eltron International Incorporated and may not be duplicated in full or in part by any person without written approval from Eltron.
Attach the ribbon to the rewind core fiberboard tube on the ribbon takeup tube with tape.
Operation Label Loading Close the eclise by pressing down on both Step sides of the front of the printhead assembly. Refer to the EPL2 Programming manual for the correct data syntax.
The sensor position is indicated by the green arrow at the Hole Position front of the label guide that is visible with the printhead open.
Other drivers most commonly associated with Eltron Eclipse problems: Warranty Information 12 months from the date of purchase by the end user. Eltron warrants the mechanism, control electronics and power supply, under normal use and service, to be free from defects in material and workmanship for a period of twelve 12 months from the date of purchase by the end user.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Ship the equipment, freight eltronn, to the address listed below: See the EPL2 programmer’s manual for details. The printer is now ready for standard Direct Thermal Printing.
The printer will automatically adjust the gap sensor and measure the label length.
Problem Solution or Reason Printer cuts melts through 1. Figure Attaching Ribbon Tape Getting Started Step Parallel Interface Attach Interface Attach a suitable parallel printer cable from the computer to the Centronics interface connec- Cable tor at the back of the printer. Check that the eptron and label stock are correctly routed. The warranty set forth above is exclusive and no other warranty, whether written or oral, is expressed or implied.
The printer will feed a single label each time the FEED button is depressed.
Follow the installation instructions on the screen to install the software. If proof of purchase or product registration cannot be established, shipment date to the original buyer dealer or distributor will be be used to establish the warranty period.
Eltron Eclipse File Name: Step Place the printer in a suitable location that al- lows easy access to all sides of the printer.